Roof Talk-101  5 Maintenance Tips to Help Prevent Roof Leaks

by Jason Joplin

One of the most common and costly issues homeowners call on a contractor for is to fix a leaky roof. Not surprisingly, most property owners do not have the expertise (or desire) to get onto their roofs and look for problems themselves.

However, even for a professional, the source of a leak can be elusive because it rarely lines up with where the water is getting into the home. Contractors need to become detectives to correctly identify the source of a leak and understand the path that water travels. Yet all of this pain can be avoided with a comprehensive maintenance program. Even the National Roofing Contractors Association recommends that roof inspection and maintenance be performed regularly to help avoid future problems.

After all, a homeowner wouldn’t expect:

• A furnace to perform efficiently if the filter was never replaced

• A car to run if the oil was never changed

Yet, they install a roof and think that’s the end of the story.

Before an inspection, the contractor should look around from the ground and ask the homeowner if there has been recent extreme weather, animals around the home, leaves, falling debris, trees, satellite or cable work, or an accident that caused damage to the roof.

Once on the roof, follow these 5 simple tips to help locate future leaks and show how a maintenance program can help identify potential problems before they cause damage.

1. If it pops through the roof look at it. Penetrations are the most common leak sources and will stop the natural water flow off a roof. Look here first to find the source of the leak:
   • Chimneys. The top leak source. Does the chimney have a cricket? Is it properly step flashed and counter flashed? Does it need to be sealed?
   • Skylights. Water gets trapped behind them. Is the flashing in good repair? Is the skylight itself leaking?
   • Plumbing vents. Do the vent stacks have neoprene or rubber that has cracked with age? Do they need to be sealed or painted? Have critters chewed on the pipe or flashing?
   • Is the satellite or cable flashed properly?
2. Living on the edge. A drip edge is not just aesthetically pleasing, it is important to help ensure water is kept away from the fascia and moved off the roof.
   • A common leak source in the eaves and cause of wood rot is a missing drip edge. Wind-driven rain will enter the gap between the roof deck and fascia board.
   • A drip edge also helps to keep out insects, critters, and snakes. Make sure to check the drip edge when looking for leaks.
3. Every step I take. Areas where step flashing should be installed are a common leak source and maintenance item. Inspect these areas for damage:
   • Dormers
   • Roof-to-wall transitions
   • Wherever low-quality sealant or mastic has been used in the past
4. What’s in YOUR attic? Many times, homeowners think the roof is the culprit, but problems can come from improper ventilation, plumbing, air conditioning, condensation, vent fans, and animal or bug infestation in the attic. Be on the lookout for:
   • Algae stains on interior plywood
   • The “M” word: mold
   • Soaked insulation when it hasn’t rained
   • Black rings or rust around nails, which is the first sign moisture is condensing in attic spaces
   • Is there a lack of ventilation that is causing the attic to overheat or accumulate moisture?
   • Are the intake vents clogged with paint, spider webs, dust, or insulation?
5. Mind in the gutter. Many homeowners do not realize the importance of their gutters. They need to be installed and sloped properly to drain, tightly fastened, and free of debris. Contractors should stress to homeowners that gutter maintenance should be left to a professional. Advise them of the risks of climbing onto a ladder.

All contractors can explain to their customers that a preventive maintenance plan consisting of periodic inspections (generally in the fall and spring), routine maintenance, and minor repairs can help avoid costly problems down the road. A thorough inspection, performed regularly by a professional roofing contractor, can monitor the roof’s condition and help prevent small problems from becoming major roof leaks.

ROOFGUARD-LLC has been installing commercial roofing systems for over 30 years. We have the solutions you are looking for if you desire a new commercial roof or need a re-roof. ROOFGUARD-LLC only uses the best products and installation practices to insure you have a worry free commercial roof. For more information visit us at. www.roofguardtexas.com and we also invite you to Like Us on our Roofguard Facebook Page .

Roof Talk-101 How Puncture Resistant Are Commercial Roofing Membranes?

How Puncture Resistant Are Commercial Roofing Membranes?

Liza Barth

Contractors are careful on the roof, but accidents can happen. Heavy, sharp tools can get dropped. Stones, loose screws, or gravel can get stepped on and driven into the membrane. These things can happen during roof installation or when air-handling equipment, etc., gets installed or is worked on during routine maintenance. Some of these accidents can result in a puncture of the roof membrane. GAF set out to compare the two popular heat-weldable membranes, TPO and PVC, together with a range of substrates. So, which roofing materials will give you less worry about punctures? GAF’s research uncovered the answers.

Puncture resistance can happen in a few basic ways. Objects can impact at slow or fast speeds and be sharp or blunt. Single-ply membranes do not have the hard exterior surface or redundant layer, which are normally part of multi-ply systems, so they are sometimes perceived as less resistant to punctures. In an effort to shed some light on puncture resistance, GAF took a look at various TPO membranes from the major roofing manufacturers in 45-, 60-, and 80-mil thicknesses and 36- and 50-mil PVC samples.

GAF tested both low- and high-speed impacts and failure was defined as the force required to penetrate the top membrane layer to expose the scrim. In the low-speed test, thicker TPO was better, and fleece-back was also an improvement. No notable difference between manufacturers was found. PVC appears equivalent, except for the 36mil material. Being reinforced with a heavier weight fabric, it showed better performance, highlighting the importance of scrim in this low-speed test.

In the high-speed test, the TPO membranes again indicate that thicker is more puncture resistant with little differences between membranes of the same thickness from all manufacturers. The 50-mil PVC samples were slightly less puncture resistant than 45-mil TPO. One surprise was the poor result of the 36-mil PVC sample (even though it did well in the low-speed test), suggesting that the dense scrim in that membrane does not help resist a falling sharp object compared to a standard scrim. As with TPO, supported PVC is more puncture resistant.

It’s important to note that low-speed manual demonstrations done by slowly pushing a pointed object into a membrane are misleading. It’s best to look at approved test methods (rather than relying on a marketing gimmick) to show how roofing membranes hold up to punctures.

ROOFGUARD-LLC has been installing commercial roofing systems for over 30 years. We have the solutions you are looking for if you desire a new commercial roof or need a re-roof. ROOFGUARD-LLC only uses the best products and installation practices to insure you have a worry free commercial roof. For more information visit us at. www.roofguardtexas.com and we also invite you to Like Us on our Roofguard Facebook Page .

Roof Talk-101 Spring Has Arrived

Roof Talk-101  Spring Has Arrived

Here are some tips to look for during spring cleaning to help preserve the integrity of your roof. 

Tree limbs. Make sure tree limbs don’t touch a roof.  If they do, they can easily scrape over the shingles and loosen the protective granules. This will severely reduce the life of a roof. Trim trees close to the house to avoid any limbs touching the roof surface.

Leaves and pine needles. A little leaf or a few pine needles are fine, but if they collect and are deep enough to hold moisture, they need to be taken off the roof.  Anything that traps moisture will cause mildew to form, block gutters, or cause extra weight on the roof. A rake or air blower can be used to clear the roof, but take care not to damage the shingles.

Moss. Cutting back trees and removing leaves will reduce moss growth, as it will allow sunlight to dry up the moisture that moss thrives on. While there are chemicals available on the market to get rid of moss, the runoff can cause damage to plants. Another solution is to nail zinc or copper strips to the ridgeline; as rain washes across, it creates an environment where moss cannot grow.

Mold. Discolored streaks on a roof indicate there is mold, algae, or fungus, which can eat away at the roofing material and, ultimately, cause leaks. A treatment of chlorine bleach or copper sulfate solution applied with a garden sprayer can kill the mold. GAF manufactures algae-resistant shingles that have a specially formulated granule that inhibits algae growth, in addition to shingles with StainGuard® Protection. Finally, do not power wash shingles! It can dislodge granules and cause premature shingle failure.

Gutter damage. Heavy snow from the winter season can result in gutter damage while leftover fall leaves and debris can lead to clogged gutters. Before the springtime rain, check to make sure water can flow easily through the gutters and fix any loose nails that are preventing the gutters from sitting tightly along the roof line.

Missing shingles, chimney, and flashing. A complete inspection by a contractor can uncover issues with missing shingles, chimney damage, or flashing around chimneys, vents, or other bends in the roof.

Dealing with these potential issues in a timely manner will allow your roof to stand strong through the next season of weather challenges—and for many years to come.

ROOFGUARD-LLC has been installing commercial roofing systems for over 30 years. We have the solutions you are looking for if you desire a new commercial roof or need a re-roof. ROOFGUARD-LLC only uses the best products and installation practices to insure you have a worry free commercial roof. For more information visit us at. www.roofguardtexas.com and we also invite you to Like Us on our Roofguard Facebook Page .